Wiral LITE can be operated by using the remote control included in the kit. The remote controls speed and acceleration as well as setting digital end stops. Wiral Lite has three different control modes.
Control the speed from 0 to 1.2 m/s (0 - 3.9 mph) by turning the speed wheel.
Control the speed from 0 to 9.5 m/s (0 - 31 fps)by turning the speed wheel.
The unit moves slowly back and forth between the digital end stops in speeds
up to 40 meters per hour / 131.2 feet per hour.
Control speed and set electronic end stops
01 POWER ON
Press the Mode Button to power on the remote control. The Mode LED will turn on. Hold the same button for 2 seconds to turn off.
02 CONTROL MOVEMENT
Rotate the Speed Wheel to move the main unit. Rotating towards the yellow arrow, will move the main unit towards the arm marked with a yellow stripe.
03 SET DIGITAL END STOP
Set digital end stops by moving the main unit to the point you want it to automatically stop and press the end stop button. The yellow end stop button will set a digital end stop on Wiral LITEs "yellow side".
04 SET SECOND DIGITAL END STOP
Move the main unit to the second point you want it to automatically stop and press the opposite end stop button. The main unit will now only move in between these points. Be aware that the end stops might drift. They should be reset after emergency stops. Use end stop clips for extra safety.
05 REMOVE END STOP
Remove end stop by holding the end stop button for 2 seconds. To replace an end stop, just click the end stop button when you want to place it.
06 END STOPS NOT SET
Setting digital end stops is highly recommended. In time lapse mode the indicators will blink if the end stops are not set.