The firmware of Wiral LITE is being updated continously. To help you install the latest firmware on your device, we have created the Wiral Updater app. Follow the steps below to get started.
Note: Wiral LITE Firmware v1.3 Please unpair the Wiral LITE unit and the remote before updating firmware, and remember that you will have to update both the Wiral LITE Main Unit and the remote to Firmware v1.3 in order to use Ping Pong Motion.
DOWNLOAD WIRAL UPDATER APP
Before you start the process of updating the firmware of your Wiral LITE, you will need to download the Wiral Updater app to your smart phone. The app is available both for iOS and Android devices.
Install and open the app on your smart phone and follow the steps below. (These steps are also described in the app)
01 SELECT DEVICE
Both the Remote and the Main Unit can be upgraded through the Wiral Updater app, but it has to be done separately. Choose which one to start with at the top of the screen. Both units should be upgraded for the firmware to work perfectly.
02 ACCESS FIRMWARE UPDATE MODE
To connect to your device, you will need to put it into Firmware Update Mode.
Turn on your Wiral LITE Main Unit. When the unit is on, press and hold the On/Off button for about 5 seconds until it turns orange (keep holding the button even if it appears to shut down).
The Main Unit will now boot in Firmware Update Mode.
Turn on your Wiral LITE Remote while pressing the right (yellow) end stop button.
The remote will now boot in Firmware Update Mode.
03 SELECT FIRMWARE VERSION
When loading the app, a default firmware will already be selected. If you want to install a different firmware, press the Change Firmware Version button. You are now able to select different versions from the list.
When the unit is connected and firmware version selected, click the Upload button to start the installation process.
04 UNPAIR UNITS
If the main unit and the remote control were paired together before the update, the pairing will be broken after the updating procedure. This means the units need to be unpaired before they can work together again. Follow these simple steps to unpair the units:
To unpair the remote control:
- Hold down both end stop buttons and the play/pause button at the same time, while turning on the remote control.
To unpair the main unit:
- Turn on the unit. Then press and hold the power button for 5 seconds, until button light is
continuously yellow (keep holding the button even if it appears to shut down)
- Remove battery to confirm unpairing.